Same person differrnt problem

[danmation]

Hello all,
Over the past few days have I learned a lot about sats and receivers. I am finally downloading to this old Fortec Lifetime Ultra with all the bins; however now I am in a mess! I am not sure what happened but after doing 1 of the bins, the box has quit working all together. Anytime I power it up it will go thru the b-75 2 times, and on the 2nd time it stops on the 5 and just sits there. After a while it goes to 5555 and sits. My question is, is there a hard reset on these boxes that will take it to ground zero, or is there a file that will work? I think I have eveything else figured out except is there an order to the bins, as far as downloading them. I have the following bins b75_m.bin, jvvh_208_1.bin, jvvh_fortec-Pansat_260_(PUFF)(Recovery).bin, convert266.bin, Lothario_268_PUFF.bin, -PUFF-_boot Ver.1.0.1.bin, Ukr_258-PUFF-RecoVVry.bin.bin., Ukr_Jvvh-Team-PUFF_269.bin, also the Blacklist 1.4.0.0 Updater, and UKRonics Box Updater 4.2. Now the question I have also is, which of these bins should I load and which should I get rid of, and second, which order do I install them in. Thanks for all your help, it is much appreciated.
Dan

[jc7257]

Try these instructions and seei f this helps. I am not big on the old Fortec boxes. I know a lot of members still use this old and outdated box. I am being honest and to tell you the truth, the aggravation with these old boxes are a headache. They are outdated and should be put away. They were great boxes in there day, but it is time to move on to newer equipment. I realize some members can't afford the new boxes, but a new Captiveworks STB can be bought for less than $100 bucks. We will always try our best to help you with any STB, just giving you my honest opinion on what you should do. Also look at the Sonicview 4000, great STB and great support...
http://www.abadss.com/forum/187-fort...onvertion.html

[basscat02]

The reset code for the Fortec and Pannys is 8282 I think