|
VS MAX HD Add-on Module SK200 & Slot Image
That’s right it is now available. They had finished production and finial
testing sooner then expected. The test results for satiability far exceeded
initial expectations and the Add-on Module was sent into production over
the weekend. There is a limited shipment of 3000 modules on the first run.
Attached are images of the SK200 Add-on Module for the VS MAX HD. You
will need to remove the current tuner module of the VS MAX HD pictured in
image VS_MAXHD_Module_04.jpg. When removing the Tuner module be
careful not to bend the 4 pins in the corner. These are guide pins used to
help guide the Add-on Module into place. You can see these in image
VS_MAXHD_Module_05.jpg
After you installed the Add-on Module go to Menu > System Information >
Receiver Information You should see the Optional Tuner Found. You can now
scan your satellites to pick up Turbo 8psk channels.
Warning:
When installing and pressing down on the Add-on Module. Do it
gently and do not force it. it should snap into place rather easy.
Always make sure you are grounded while doing this procedure to
insure your static free.
note:last pic Slot image of where the Add-on Module will need to be placed.
Last edited by edwinsao; October 2nd, 2008 at 11:39 PM.
|
Linear Mode
