Will this setup work

[kboom1]

I have a 90cm ws dish HH42 motor and Invacom QPH031 lnbf will this motor work to get all my sats on usal or will I have to use DiSEqC 1.2?
is there any issues with this motor? I dont see any post on it.When I ordered it They said it replaces the SG2100 because of clones****ing with nfuion HD in northeast.
Thanks in advance KB

[y0da]

usals should work just fine.

[joey32]

Sounds like a work in progress. The usals will work.

[tomcat01]

the motor and dish and lnb are fine but the nfusion HD does not have blind scan so you will have to enter in all the tp freq manually i found it was not to great at moving a motor still workable ..

i have a sat file with most in there already socould use that to start .. good luck all else seemd good .. 36 inch dish is the perfect size

[kboom1]

is the sat file posted? I found one on another forum that i put on for updated tp from jul 7th.didnt see any others

[tomcat01]

if it has free to air tp freq good just go through them and make sure they are up to date for scanning

best sats

123w
83 w
125 you can also pick up pbs HD here
101w

a few channels on 72 w and 77w

when you are all hooked up and on the arc post back and someone can help ya .. if you want international ia5 97w lots of free to air

[kboom1]

cant seem to find arc.I'm using info from dish pointer.XXX It says my dish elevation is 24 but seems real low .cant find exact settings on page for my motor.guy from tec support from co i bought dish from said follow guide for sg2100 so I dont know if setting is correct.also he said to put DQ switch between lnb and motor C on port 1 and L on port 2 is that correct ? I tried even running C in to motor to get signal but still nothing . dont know if it is a setting in nfuion HD wrong or other hardware prob. do you set up in usals or 1.2 also what lnb setting do i use . thanks for help in advance.KB