Reviving pansat with Boot60

Boot60 To Revive Pansat Receiver iF you receiver is completly dead this procedures will not work, sometimes the receiver after a while off might come back to life when you turn it back on. This does not happen often only if you lucky. Good luck !

1. Switch 2500a off in back.
2. Open the Blacklist Updater v1.4 software
3. Click the button that says "BOOT" in the updater window
4. Load Boot60.bin in "SELECT BIN" window
4. Turn on back switch and quickly get ready to write the bin
5. On the third light - - - start the download ("WRITE BIN") and let it finish.
6. Turn off pansat backswitch, count to 5 then turn the switch back on.
7. Now you should see Knightrider lights - - - - over and over. This is normal.
8. Load the Pansat 2500A_040607_222_api(N).bin in Blacklist Updater
9. Click the button that says "BIN"
10. Click "WRITE BIN"... let it complete. The reciever will reboot when done.
11. Let the pansat boot up all the way and leave it turned on.
12. In the Blacklist Updater, click the button that says "BIN"
13. Load the X-85BL_050905_251_api(N).bin in the Blacklist Updater ("SELECT BIN")
14. Write the bin and let the receiver reboot by itself.
15. Now you are done... just load a good channel list or rescan and watch TV again.
http://www.abadss.com/forum/pansat-2...-receiver.html