SV Premier issues

[slipform_06]

Ok guys....been reading for weeks.......trying to install ihub.......run system clean....then charlie fix 175.....then new beta 239.......get rolling screen black and white......press yellow button then up and left.....goes black. Am I doing something wrong ? someone please help

[bigevil69]

load the jan 9 file then load the new ihub file that just came out and check your ihub settings

[slipform_06]

done that all ready......can't get to ihub settings because screen is rolling do I need to load jan8 file then try to find ihub then load new file or have I missed something here ?

[bigevil69]

try this to stop rolling

try this:while receiver in standby mode, press RED function key + 2+5+8+0. This will swith from PAL to NTSC and reverse

[RICKSBEACH]

slipform.. you get it fixed?

[slipform_06]

no deal.....still rolling.....shows ntsc, but still black and white and rolling

[slipform_06]

not yet...severely needing help

[bigevil69]

sounds like your tv may have got switched some how can you try a channel you have or dvd player

[slipform_06]

can switch to my pay sat...dn and works fine.....not the tv........run system clean again...load charlie 175...everything ok...load new beta file...screws up

[RICKSBEACH]

you have loaded this new file for the ihub:
http://www.abadss.com/forum/960-sv-3...ta-june26.html

Originally Posted by slipform_06

can switch to my pay sat...dn and works fine.....not the tv........run system clean again...load charlie 175...everything ok...load new beta file...screws up

[slipform_06]

yes....
still the "grey" rolling screen...switch to NTSC and still rolls..........

[bigevil69]

go back and reload the clean system file again and see if that stops it

[slipform_06]

done that 4X all ready......system reset twice......reloaded all files....still crap.
gotta be missing something.

[bigevil69]

if you have the premier load this file

http://www.abadss.com/forum/960-sv-3...ch-2009-a.html

[slipform_06]

Thanks to all who helped....got lucky......SV premier
To avoid the gray rolling screen do this.....
load bin file, and reboot
when the screen comes up it will be gray and rolling. press yellow button then up then left. Turn the unit off with the remote.....then back on. If still rolling turn off with switch on back of unit for 30 seconds than back on....should fix screen roll....

[RICKSBEACH]

good to hear you finally got it fixed...
I went looking at previous post last night as someone else had the same problem as you had last week..I couldn't find the thread..
I'll see about making a little sticky for this ..
thanks for getting back to us and letting us all know that your up and freezing again....
lol..