No HD Channels detected (DVBDream/skywalker-1)

[zbluedot]

Having no luck getting HD channels... All non HD channels ok. Tried manual scan on HD transponders listed on lyngsat - no channels detected. any suggestions?
Setup:
Intel Core2 Quad CPU Q6600
3G Ram
GT8500 card
skywalker-1
DVB Dream v1.4i
Emunation v3.0.3.9
Tried various codec combinations, no HD... currently set to nVidea PureVideo(Video), InterVideo (Audio), VMR9, SPDIF Out, CoreAVC(for HD, but also tried ArcSoft, CyberLink)

[antivirus6613]

What sat are you pointing to?

[hazwis]

yea, if your trying to get HD on dn then it requires and 8psk module to decode that signal. i dont know if what you have is capable of decoding that signal but you can always read the specs on the hardware.

[zbluedot]

antivirus - sats 110, 119, 129.
hazwis - skywalker-1 and dvbdream + emunation should handle it. Could it be the wrong LNB on the dish?

[antivirus6613]

Your LNB should be fine if you get signal but I am thinking that maybe some type of 8spk is needed. I don't know much about PCI cards however.

[zbluedot]

I am using skywalker-1 (USB2). It seems that the HD channels are not even being detected when scanning (auto and manual).

[Beast2394]

I have this same issue, did you figure out a fix? I also have a skywalker.

[dsstbuster]

I, too, am having the same problem. It's my understanding that the Skywalker-1 has a built in 8-PSK module!