Steps to make your coolsat ready with card - Page 2 - ABA DSS

BruinsFan · August 2nd, 2006

ok thanks guys, I will try later. The reader is the original but never have I seen the cas slot one info in the menu. will try it again thanks GO REDSOX

BruinsFan · August 3rd, 2006

tried everything, card reader just dosent intialize and I dont have a ca option in my menu. have all locals so I know right version is there just no menu option.

GO REDSOX

**bel71281** · August 3rd, 2006

are u writing the 125 or 127 bin?

BruinsFan · August 3rd, 2006

127 bin, I have locals, and it says ver127, however my boot version is 1.20 (9:05) I read somewhere it sould be version 2.1 any ideas?

GO REDSOX

**grasshopper** · August 3rd, 2006

Did you press 8282 on your remote?

direct · August 15th, 2006

instead of a card reader why not plug into your puter and have numbers rolloing all the time

**bel71281** · August 15th, 2006

????? the card reader is not for the key rolling. its the way around the map57 problem. with the card reader you can use the aux file and a rom card to get around it.

**tango** · August 15th, 2006

IF you have an iso programmer.
-Do a simple ATR reset in NagraEdit4.1
If you don't (disconnect your sat signal from your ird)
-Pop the card into your ird and pull it out when you see the receiver turn on, it will goto the sysinfo screen and you can see by the DNASPXXX and the REVXXX.
Both simple and easy way to find out and neither will screw the cards.

LEAFCITY · August 19th, 2006

Where Can I Get A Coolsat 5000 Card

ftamike · August 19th, 2006

try ebay

10--84 4E 77 C8 56 91 5F BC

11--08 DE 10 D6 D2 91 7E F7

20--98 F5 81 B3 1E 96 00 3C

21--67 59 AE 1E D5 2E 1F D2

1) Press 8282 on your remote