1st Timers How To For Loading Bins

[bigevil69]

Loading the Coolsat with the new “Bin” file
Follow the simple steps below.
1. Turn power OFF on Coolsat with the front button.
2. Turn OFF rear power switch.
3. Unplug the Coolsat (The power cord 120 volts).
4. With all power OFF, connect the RS232 cable from Coolsat to PC.
5. Plug in the receiver (The power cord 120 volts).
6. Locate and execute the application “Coolsat Pro Loader v2.4” software.
7. Turn power ON from the REAR switch located on the back of the Coolsat and turn ON front power button
8. Locate the file for your Coolsat 4/5/6000, it would read “NORW_1.20.stb” or current BIN file.
9. Select the Coolsat 4/5/6000 “NORW_120.stb” file then click on the “Open” button.
10. Click the button “Auto Detect” to see if port setting is correct and your Coolsat is communicating to the PC. If port setting is correct, the Com port and current BIN version loaded to the receiver will show
11. Click Exit to exit the Auto Detect
12. Click on the Connect button another window will open then click on the Start button to continue the programming. You will see System Reset, Sending percent, Sending Ok and Erasing the BIN . !Do not interrupt this process until the “Finish” window opens! The Finish window will show the prior version of BIN loaded
14. Click on the “Finish” button to continue and exit
15. Verify the “Bin” file by clicking on the “Auto Detect” button, the current version “bin” loaded will appear
16. Exit out of the Coolsat Pro Loader program by clicking on the “X” on the upper right hand application window.
17. Turn OFF Coolsat with rear reset button.
18. Disconnect RS232 cable from your PC.
19. Install your Coolsat to your TV set
20. Unplug the power cord of the Coolsat.
21. Reconnect LNB cable in and cable out to TV.
22. Plug in Coolsat.
23. Turn ON rear reset switch.
24. Turn ON front button and wait for clock to come on. If first time flash of receiver wait until you see 0000 to show up on clock