Copy & Past
Use at your own Risk
These steps were taken with an Original 2500A...The most important part of this conversion is to "BE PATIENT." Your 2500A will have abnormal displays but this is part of the process.
There are many that have had problems using the conversation files and I have been successful with the conversaton and wanted to provide a step by step on the process.
The files that are needed are located here
http://www.abadss.com/forum/162-pans...2700-file.html
---DO A FACTORY REST ON THE 2500A BIN BEFORE COMPLETING ANY OF THE BELOW STEPS---- I ALSO LOADED THE 236BIN BEFORE I PROCEEDED. Found here....
http://www.abadss.com/forum/162-pans...ansat2500.html
---Connect your 2500A to your computer but "DO NOT TURN IT ON"
---Use the BlackList updater 1.4 which is included with the download. Open and run the BlackLIst updater 1.4. (You are writing a BIN so make sure BIN is selected)
--Choose the correct Com Port
--Select the j27_205_1.bin. (Wait...Dont proceed)
VERY IMPORTANT
---Turn your 2500A on from the back and at the first sign of light on the display, CLICK WRITE BIN....
---Your receiver will upload as normal to 100%...The receiver will reboot and show B75. BE PATIENT this may take a few minutes.
---After B75 is displayed the receiver will either show "ON" or display a channel number.
---Turn off your receiver from the back
---Now select the jvvh_208_1.bin. (Wait...Dont proceed)
---Again turn on you 2500A from the back and at the first sign of light on the display, CLICK WRITE BIN....
---You receiver will
not count up a precentage....The display will look abnormal. "BE PATIENT" Wait until the receiver reboots, shows B75 or just 5 and wait until the unit shows "ON" or a channel number.
Once complete you now have a Pansat 2700. Your new receiver will now always boot showing the B75 or 5 and then show the channel number or on. The B75 or 5 will display for about 5-10 seconds
Now you can scan your channels as normal. I always scan the highest number birds first. The installation screen onlly shows the follwoing birds....
UNUSED
110
119
91
I am not sure why but it may be to conserve memory. Make sure you set the default key, turn autoroll on and change your time setting so that your EPG displays properly.
This worked flawlessly for me on the first try........Autorolling better than ever....
Thanks to No_PaRoLe
Good Luck everyone - Happy testing
GH
Linear Mode
