Pansat 2500A - Write Failed [ER1] - ABA DSS

coupon · April 7th, 2009

I had successfully flashed my Pansat 2500 previously with this computer and Serial Cable.

When re-flashing it today it now says WRITE FAILED [ER1].

Getting nothing across the front LED's.

Any idea on how to correct this?

**cdo_care** · April 7th, 2009

Reload the factory Bin bud. Sometimes this unit go in 10x try.

coupon · April 7th, 2009

Have tried this from multiple computers with multiple loaders.

**boboisno1** · April 7th, 2009

Have you done the 1.0.3 conversion to it? If so try different loader versions.

coupon · April 7th, 2009

I was in the middle of trying to convert it.

Using the same Cable/Computer I can flash other device, so it appears to be an issue with the unit.

Any way to open it up and reset the memory?

**boboisno1** · April 7th, 2009

Try doing it a few times. Make sure you use the right loader for the conversion then use a different loader for the file loading. I can't remember if its loader 420 for the conversion and 421 for the file. I will check.

**boboisno1** · April 7th, 2009

I have it backwards .421 is for the conversion.

coupon · April 7th, 2009

Still no luck with multiple loaders and bin's.

Any other ideas besides making it a doorstop?

**boboisno1** · April 7th, 2009

Do you have any lights on the receivers display?

coupon · April 7th, 2009

No lights at all.

I can see the TV flicker a bit when I turn it off/on. So there is power, but it seems the ROM is a bit out of sorts.

easterbunny5152 · June 22nd, 2009

I tried flashing bin file from another site put it into the three light mode
had to factory flash it.
where can I get and how to make this receiver work
(Pansat 2500A)
Thanks for any and all help!

gstv · June 22nd, 2009

can not do it wont work i try it

**MYCOCONUT** · June 22nd, 2009

I had one of those units , and had the same problem, make sure your using the correct com port settings.

**rr52** · June 27th, 2009

I check the com port always before I load a bin. Sometimes it's 1, most of the time 2, but I always have to check.

ftahound · July 14th, 2009

find the how to jtag manualy have to take box apart to see wireing have to make jtag plug seen done once brings box back to life .... just dont remember how to.....

**tiger-55** · July 14th, 2009

Even if you got it flash but there is going to be no tv.as you know all channel move to n3.if you like to get more info just go to your receiver info. Go to home page in upper left corner, click on drop down arrow next to sonic view and select your receiver.All the info is there...good luck