Pansat 3500sd loads to B-80 only

[ivebeen4given]

My pansat 3500sd will only load to have b-80 on the front screen and wont go another farther.

What is wrong and what can I do to fix it. I hooked it up monday and it did this last night. Thanks in advance for any help.

[hunter50]

Originally Posted by ivebeen4given

My pansat 3500sd will only load to have b-80 on the front screen and wont go another farther.

What is wrong and what can I do to fix it. I hooked it up monday and it did this last night. Thanks in advance for any help.

did you load the current bin

[odissseusss]

Try to load a factory bin and then the latest bin.

[carlos60]

Go here and read the instruction first
http://www.abadss.com/forum/126-pans...80-update.html

when you finish install the Last bin again

Originally Posted by ivebeen4given

My pansat 3500sd will only load to have b-80 on the front screen and wont go another farther.

What is wrong and what can I do to fix it. I hooked it up monday and it did this last night. Thanks in advance for any help.

[ivebeen4given]

the last BIN I put was 376. When I first got it I couldnt update using the loader and the null cable it said something about missing 3500S. I looked at the above link how do you open the *.rar file.

[hunter50]

Originally Posted by ivebeen4given

the last BIN I put was 376. When I first got it I couldnt update using the loader and the null cable it said something about missing 3500S.

make sure to unzip the file and then load if still says than setting may be wrong in the loaderand use 377 bin

[ivebeen4given]

I finally got my box connected to my computer and I have it working again. Thanks for all the help.

[odissseusss]

Was you receiver working before this??
What was the latest bin you did use??
If you try to upload a bin and the receiver stays only in b-80 , try loading a b-80 factory bin http://www.abadss.com/forum/164-pans...-b-80-v04.html

wait for the receiver to restarts and then load latest bin http://www.abadss.com/forum/164-pans...3500-v389.html

[odissseusss]

Hmm ok load factory bin v2 or v3 and see if the receiver boots. If its ok then load latest bin. Try that and let us know.

[odissseusss]

Hmm ok load the first b-80 factory bin and try to load latest.

[odissseusss]

If the unit turns on you don't need to jtag it. Simply load boot b-80 using serial cable wait for the unit to reboot at this point if you want load a factory b-80 bin or simply load latest bin. Try that and let us know.

For the jtag cable you have , check that it has the 5 100ohm resistors inside if not that could damage the unit.