Entering Keys Manualy - ABA DSS

**carpenter1** · October 20th, 2006

01 - Press MENU on the remote
02 - Press down ARROW on the remote to go to Channel Edit menu
03 - Press OK on the remote to enter Channel Edit menu
04 - Press down ARROW on the remote to go to Code menu
05 - Press OK on the remote to enter Code menu
06 - Enter "0000" for the password
07 - Press down ARROW on the remote to go to Nagravision menu
08 - Press OK on the remote to enter Nagravision menu
09 - Press right ARROW on the remote control until you see provider 09 01 00 ExpressVue and you should see 00 for Key Number.
10 - Press right ARROW on the remote control, you should now see no provider, by that I mean all entries should have the letter "F".
11 - Press left ARROW on the remote control, you should now be back to provider 09 01 00 ExpressVue, however for Key Number you should see 01.
12 - Press down ARROW in oder to position the cursor on the first row of keys
13 - Enter the first 8 pairs of the key sequence and press OK on the remote which will save the key just entered. It may take a few seconds, there will be no message but if you would press down ARROW immediately after the OK the cursor would not move to the next line.
14 - Press down ARROW in order to position the cursor on the second row of keys.
15 - Enter the second 8 pairs of the key sequence and press OK on the remote which will save the key just entered. It may take a few seconds, there will be no message.
16 - Press EXIT (4 times) to go back complete out of the menu section
17 - Press SAT on the remote and choose Nimiq 1.3
18 - In the channel list go to MCTV (helps if your channels are in alpha order), using any other channel did not work for me I would always be stuck at 1%
19 - Press OK to select the channel. You should now see a picture within less then 10 seconds.

**carpenter1** · October 20th, 2006

Once you download Key Ripper & install it, just click on "Get Keys" while you're connected to the internet. It will find them real quick. To enter them in your unit, you will need to press the number keys more than once for the corresponding letters (like a cell phone for texting).

Example... if you need to enter the letter C, press the number 2 four times. The letters are listed by the numbers on your remote, just like a phone. Hope this helps.

**bobsp** · October 20th, 2006

Thank you for the info, however that is the problem. "Code" is not an option to choose...

**jessica92783** · October 29th, 2006

Hi
Capr Please Help Me
I Have Problem With My Panset 5000hc