The Best Way To Load a CW600S Regular With Kround Software Allready Installed

[arboristman]

c&P

These instructions are only recommendations but I believe in them 100%. If you follow these instructions exactly I believe they may solve allot of problems when loading bins.

CW600S Regular

1. Write down your dish settings (you will need them for step 8)
2. First do a Factory Default!! [Menu-Installation-Factory Default]
3. Load Factory Flash V1.14 for CW600S Regular (very important to load the proper bin)
4. Do another Factory Default (same as Step 2)
5. Load the newest Bin.(check the downloads section)
6. Do another Factory Default (same as Step 2)
7. Load Long Channel Names (this is optional)
8. Setup all your dish settings (they should be all marked down on a piece of paper as you did on Step 1)
9. Do a Auto scan of Sats (Menu-Installation-Antenna Setting)
10. Enable Patch (F1, then 000)
11. Set Timer Setup (Menu-Channel Manager-Timer-Timer Setup)

**Note** Remember to always turn off your Stb's by the switch on the back of the unit before you disconnect or connect the coax cable or you may damage the Stb. Also always make sure you down load the proper bin for your Captive Work (CW600S Regular, use CW600S Regular Bins or if you have a CW600S Premium, use CW600S Premium Bins). Very very very important.