|
how to clone box to box
cw600s box to box complete clone.
Turn both box(s) off.
Attach Null Cable to Master and Slave unit
Turn on Master in boot Mode.
Turn on the Slave Receiver.
You should see the H in the Master Display.
Enter 444 in your remote to clone the entire box.
When -End appears on the master it's done.
You will not see anything on the new unit in the display window at this time.
Turn both units off then back on again.
They will be Identical including all channel settings and lists if used.
(master will be the box that is all setup good.and slave will be the one that gets the copy from the master)
|
Linear Mode
