reciver keeps trying to boot

[wildan38225]

Hey everyone, I tried to clone my 600s like i always do and the slave reciver keeps trying to reboot over and over. I am stumped on how to fix it. I was wondering if someone might could tell me how to fix it?

[sayyad]

remove all cables, switch it off for while and try to reload it again

[wildan38225]

i tried that when i turned it back on it just keep rebooting

[antivirus6613]

Plug it into computer ready to hit the load, download or whatever button is in the loader. Flick the box's switch and then instantly hit the load button and it will load instead of rebooting constantly. After it loads it should be fine.

[wildan38225]

if I hold the power button and turn the swich on then try to load it it will start to load and then show eo11

[antivirus6613]

Hmm. Turn the box off. Let it collect dust. Then retry the above procedure. Is the serial cable the proper one and is the bin and loader the latest?

[wildan38225]

yes, i have 4 600s recievers and this one is the only one i have had any problams with. I always fix one and clone the rest it has always worked fine

[littlebobo60419]

can it be done with the usb connected to the rs232 cable?or do it have to be the rs232 cable only?

[wildan38225]

I was just using the null cable to clone. I finally fixed the box, I gao it in boot mode and cloned the sw off one of my good ones and after that i programed it with my usb cable off the comp. and so far so good it is still working. thank you for your help.