quality 0%

[porshe_lama]

I have a CW600s, strengh 80% but 0% quality I can not see any channels, somebody knows what I have to do to fix it?

[spyder123]

what bird are you aiming at? sounds like you need to re-align your dish a bit

[porshe_lama]

119W, it's not a problem of aligment because the same antenna and LNB are working with a dish system using a card. but when I connect the CW600s and scan the channels of those satellites no channel is found.

[spyder123]

maybe it's a problem with your settings. if you can post them, it may give a clue if something is set wrong. usually if you have no quality your alignment is off.

[fordman01]

Originally Posted by porshe_lama

119W, it's not a problem of aligment because the same antenna and LNB are working with a dish system using a card. but when I connect the CW600s and scan the channels of those satellites no channel is found.

give what kind of dish and lnbs????? cause it could be in setting in your receiver

go to menu and then to installation then to antenna setting try this

this is for dppro lnbs

119
transponder 12239
lnb freq. 11250
lnb type ocs-dp
22kzh off
diseqc lnb1
legacy sw off
motor off
auto scan(red button) if you are hitting satalite

110
transponder 12239
lnb freq. 11250
lnb type ocs-dp
22kzh off
diseqc lnb2
legacy sw off
motor off
auto scan(red button) if you are hitting satalite

f1000 enable patch
hope this helps

[basscat02]

Spyder is probably right on it with the settings being your problem. Just check any of the connections that are different between the 2 STB's. Let us know how you come out. Fordman's connections look good except TP Freq. on 110 is 12224

[porshe_lama]

I used this configuration

119
transponder 12239
LNB freq. 11250
LNB type ocs-dp
22kzh off
Diseqc lnb1
legacy sw off
motor off
auto scan(red button) if you are hitting satalite

and it works but i'm getting scrambled channels

[vtoskov]

Originally Posted by porshe_lama

I used this configuration

119
transponder 12239
LNB freq. 11250
LNB type ocs-dp
22kzh off
Diseqc lnb1
legacy sw off
motor off
auto scan(red button) if you are hitting satalite

and it works but i'm getting scrambled channels

If the channels are all scanning in just make sure that the patch is enabled by pressing F1 and 000 using your remote.

[EVERLAST]

if you only have 119 why u have it on ocs-dp you should have it on standard and port none tp freq 12224

[porshe_lama]

you were rigth its working, I got a question, why only 121 channels and the most of them are from LA area?

[basscat02]

You scanned incorrectly or your settings are still off. Please tell us what kind of dish/LNB you have and give us the settings you are using

[porshe_lama]

I changed ocs-dp for standard and now everything is working fine, thanks everyone i appreciated your help.