Revive Dead cw 600s premium

[jukebx]

Followed the first step: use loader 1.05 then set reciever to boot , ran CX Kround1.13, turned off reciever and turned back on and all i get is boot flashing. can't clear flashing boot.

[arboristman]

jukebx,

you list your cw 600s as the "premium" model.
however i believe your using the 1.05 loader for the 600s regular.(there was also a 1.05 loader version for the premium prior to the release of 1.06)
the reason is,because you mention using CX Kround1.13,which is for sure for the standard 600s (non premium).

its important to understand the 600s and 600s premium are only the same in regards to a poor manufacturing mistake imho by calling two units the same model numbers.
this mistake has cost many a receiver and i fear you as well.

[arboristman]

if you have the premium this would be incorrect:
looks like your following this guide for the 600s(regular):
http://www.abadss.com/forum/169-cw60...-receiver.html



but if in fact you have the 600s premium.you should seek this thread instead:
http://www.abadss.com/forum/133-cw60...help-here.html

[jukebx]

Can not find V1.08 factory files or V3.01 CXLoader

[VGiddy]

jukebx - All the required files are in this location.

ABA DSS - Free to Air Satellite TV Community

Unzip this item and all those files are included in this folder.

[jukebx]

Thanks my reciever is back up however the file2.30 puts funny clors on my set up and the epg is black on the line you select

[tnp12]

try a hard reboot and double check your settings.

[arboristman]

load the latest file again buddy.