[sayers]

Hey all,

I just flashed using the loader 1.06 and used bin 1.36, when I turn the reciever on and Press power on the receiver I get a message that says No Channel, when I go to turn the channel to say 222 it says Invalid program, I pressed Menu on the remote but i'm not sure if I have to configure anything with those options?

[coorslightly]

your using the older bin there is a new 1.37 for your receiver now in the download sections of captive works

[sayers]

Just installed the latest 1.37 bin, still the same problem...I get the gold coin with the "i' in the middle logo thing, that says NO CHANNEL. If I try to change the channel manually to say, 222 it pops up with a logo thing saying INVALID PROGRAM.

Does anyone know why I'm getting these errors or if I have to config or do something else to get channels?

[coorslightly]

did you change the keys ? tonight and also turn it to a channel you watched last .

[sayers]

This receiver is brand new right from the box, I just hooked it up and flashed it with the latest bin file, I never hooked it up and went into the Menu's to change any settings or anything...so I don't know if i left some steps out, or what...I'm hoping I can get through these problems so I can enjoy my fta receiver.

[Rainbow]

I think you have not yet done the Scanning procedure, & also the Patch enable procedures, available at this site. After loading the correct bin file you mst scan the channels before beeing able to view them. Please see the manual for scanning procedures, & Patch enable procedure at this site.
Rainbow

[jozefs114]

could you put the link for the 1.37 download.thanks!

[kaly1972]

cw600.just downloaded 1.59 and i got flashin 2--2 # i can;t go nowear .is it viu .help

[riptorn_99]

U need the new BIN that one is older than moses

[nor2003]

for captiveworks sw600

v.159 bin files

[Rainbow]

Try the latest bin CW600 P V1.66