Fixing Dead or Red Light Syndrome On Cw600 Regular & Premium

[fordman01]

Fixing Dead or Red Light Syndrome On Cw600 Regular & Premium.
If you are experiencing a Dead, Red Light Syndrome, Dim or no display on your Cw600S or Premium, here are some instrucctions on how to fix it.
C/p
1. Remove top lid by removing all 5 screws.
2. Measure the 3.3 volts, If this voltage is 2.8 volts or lower, the power supply needs to be fixed.
3. Turn power OFF and Remove the power supply board from chassis.
4. Visually inspect the capacitors C16 and C17 (Cw600S Premium), C11 and C12 (Cw600S Regular). If these capacitors show signs of swelling and bulging on top or bottom, is time to replace them. Capacitor Values are 1000uF/10 volts
5. Desolder the capacitors using a solder sucker. Do not apply pressure to pads or lands.
6. Install the new capacitors with the proper polarities to avoid further damage to power supply board.
7. Solder the installed capacitors, becareful not to apply pressure with soldering iron as this will damage the pads or lands.
8. Install power supply back on the chassis and power STB back ON.

[jaycool]

Originally Posted by fordman01

Fixing Dead or Red Light Syndrome On Cw600 Regular & Premium.
If you are experiencing a Dead, Red Light Syndrome, Dim or no display on your Cw600S or Premium, here are some instrucctions on how to fix it.
C/p
1. Remove top lid by removing all 5 screws.
2. Measure the 3.3 volts, If this voltage is 2.8 volts or lower, the power supply needs to be fixed.
3. Turn power OFF and Remove the power supply board from chassis.
4. Visually inspect the capacitors C16 and C17 (Cw600S Premium), C11 and C12 (Cw600S Regular). If these capacitors show signs of swelling and bulging on top or bottom, is time to replace them. Capacitor Values are 1000uF/10 volts
5. Desolder the capacitors using a solder sucker. Do not apply pressure to pads or lands.
6. Install the new capacitors with the proper polarities to avoid further damage to power supply board.
7. Solder the installed capacitors, becareful not to apply pressure with soldering iron as this will damage the pads or lands.
8. Install power supply back on the chassis and power STB back ON.

Before you try this, try cloning it to another receiver and this should bring it back, I know it worked for me.

[kenv]

What is cause the power supply kip blowed the fuse.