Ch help!!!

[jt.8889]

I was having a problem with my viewsat vs 2000 platinum ...i was getting a NoCh message ...but they told me what to do and i did it but i dont get all the changels...i live in the west coast and i dont see the east coast chanels ...i dont know what i need to do i have a dish that says dish500 and its round .... my current antenna settings are
for the Echostar 8 10
LNB = on
LNB type = standard
LNB Freq = 11250
22khz = on
tp freq = 12253
diseq= port4
motor= installer
legacy SW = none

and for Echostar 7 i have
LNB= on
LNB type = standard
LNB freq =11250
22khz = on
tp freq= 12224
diseqc = port 2
motor = off
legasy= none


Please HELP!!!

[hazwis]

try changing the lnb type to ocs-dp and put 119 on port 1 and 110 on port 2.

[boboisno1]

Just a note JT, try and keep you questions for this in one post. This way we can see what advise you've been given and we will be able to help you better. The link is where the first post is. Look there if you can help anyone.

http://www.abadss.com/forum/135-view...help-noch.html

[carlos60]

Normality Dish500 use Dual LNB, NOT standard LNB, I will mark in RED your setting, check and look that the signal power is strong,Now make AUTOSCAN per sat to recover all channels back,Don`t make a Blindscan

Originally Posted by jt.8889

I was having a problem with my viewsat vs 2000 platinum ...i was getting a NoCh message ...but they told me what to do and i did it but i dont get all the changels...i live in the west coast and i dont see the east coast chanels ...i dont know what i need to do i have a dish that says dish500 and its round .... my current antenna settings are
for the Echostar 8 10
LNB = on
LNB type = standard ( OCS-DP )
LNB Freq = 11250
22khz = on (OFF)
tp freq = 12253
diseq= port4 (? DEPEND YOUR CONNECTION WITH THE SWITCH )
motor= installer( OFF only if you have NOT installed )
legacy SW = none

and for Echostar 7 i have
LNB= on
LNB type = standard ( OCS-DP )
LNB freq =11250
22khz = on (OFF)
tp freq= 12224
diseqc = port 2
motor = off
legasy= none


Please HELP!!!

[wheeler18]

I can't get the satellite name to come up in the blue on the top right hand corner. Any ideas?
these are my settings:
Satellite Nimiq 1,3 91.0W
LNB Power: On
LNB Type: Standard
LNB Freq. 11250
22KHz : off
TP Freq. 12224
Search Option: All
DiSEqC 1.0 Port 1
Motor Off
S 81%
Q56%

HELP

[tnp12]

first of all you hijacked this thread, that is a nono, after this start a new thread and you will receive better help.

your quality could be higher, make sure you are on the right sat and tweak the alignment, try for 75%+.
in the settings select nimic 1,3 then press ok, if it doesnt stay try a hard reboot with the switch on back.