need some HELP ???? - ABA DSS

cuttergrind · July 30th, 2008

I am hooking up my friends extreme and pointing at bev91 and echostar3 61.5. We got good levels and quality outside and channels were coming in good( ran each sat directly to set up then hooked to the disqec switch). went inside and hooked up to tv and channels were working then 5 min later all level and quality on bev went to zero.the echostar3 61.5 are still working. went outside disconnected the switch and hooked bev direct with no switch and still nothing. tried new lnb still nothing. dish is still tight and did not move I always mark settings on mast incase have to move the dish later. took back switch and got new one and still nothing. any help is good.

**bigevil69** · July 30th, 2008

make sure the ends on cable is good and make sure little copper wire in center is not broken

**mountaineer** · July 30th, 2008

What are your settings in the receiver? What type lnb are you using? What bin # did you load into the receiver?

**tb1971** · July 30th, 2008

Do you have the newest bin loaded? If not here is the link to it:
Viewsat Extreme Downloads - ABA DSS - Free to Air Satellite TV Community

**johnnybluedawg** · July 30th, 2008

u recheck ur dish with a signal finder to make sure u gettin good signal right at the lnb ?

cuttergrind · July 30th, 2008

bin# dpsw-080723X,settings right now are nimiq1,3 standard,11250,disqec none(because using no switch)

**tnp12** · July 30th, 2008

there is a newer file than that out, from the 27th I think, try that one.