Ariza:
Code:
1. Press Green button
2. Press Red button
3. Press Red button
4. Press Menu button
5. Press right arrow several times until you see nagravision.
6. Now depending on the key that changed and is active you must scroll down til
proper key to be changed.
Example: On 06/09/05 ECM key 01 is active. Scroll down to provider 000101 key
line 01 and enter xx xx xx xx xx xx xx xx (enter number with your # button in your
remote and for letter follow code definition button on your TV screen)
7. Press OK for 5 seconds.
8. Exit, exit ...........
9. Change channel and watch TV.
Ariza 700:
Code:
1. Press Menu
2. Scroll Down to Parental Control, Press Enter
3. Press "i" key on remote, then enter pin number "2004"
4. Scroll down to Set Default Key, Press Enter
5. Scroll up to Nagravision, Press Enter
6. Press VOL Right twice, you will see Dish Network
7. Press CH Down once, then VOL Right Twice, you will now see Nagravision 2
displayed top left You are now at the key 00, Press CH Down once so you can edit
the Key Data
8. Enter your new keys (write down the old ones to be safe)
9. Press Ok to store, then repeat with key 01
10. Press exit until you get back to tv, all channels will be available
Ariza Extreme:
Code:
1. Press “Menu” on remote
2. Press right arrow to “Expert” with remote.
3. Press “1-2-3-4” quickly on remote. This will bring you into the “CAS system”
Menu. This is where you enter/alter data for all services you wish to test.
4. using the arrow keys to navagate , move to the appropriate index for the desired
provider, then to the key & select “ok” on remote.
5. Using the arrow keys on remote to change selected values for the desired
provider/key.
6. Using your remote, select and change the “key 00 data” with new correct
information, then press “exit” on remote to store your changes.
7. Using your remote, select and change the “key 01 data” using the same method
described for changing key 00 ,steps 4 - 6 substituting the key 01 index/key line
and correct data for key 01. Enter the new 01 data, then select “exit” on the
remote to store your changes.
8. Press “exit” on remote untill you reach view mode, then wait approx 15 seconds
and your reciever should beging to process correctly again, allowing you to view
video again until the next change. You must then obtain current/new data and
repeat this process over again substituting the new updated data.
8a. If after completing all listed steps you still fail to recieve video , then review all
data as entered as well as all setup and installation settings ensuring they are
correct and you are recieving signal from the correct satellite/s.
Quote:
Originally Posted by milton montesqu
COMOPUEDO PONER LAS LLAVES DISH 0101 EN MI RESIBIDOR POR QUE NO ENCUENTRO LAS CLAVES
ALGUIEN ME PUEDE DAR LAS CLAVES DISH O1O1 AND DISH 0106 PLEASE  |
Linear Mode
