Pansat 2700 with scrambled channels

[cangrimanjdj]

I have a 2700 Pansat setup with 2 dishes. Dish pro. Using my legal 301 box I can see all channels I'm subscribed as usual. When I hook up my Pansat, some channels can't be seen.
I have B-75 installed with the latest keys and still can't see some channels from 110. The message says "Scrambled" or "No Signal".
Could anybody help me? Could it be the dish is not completelly aligned? My installation was made by a Dish professional.

[jc7257]

Originally Posted by cangrimanjdj

I have a 2700 Pansat setup with 2 dishes. Dish pro. Using my legal 301 box I can see all channels I'm subscribed as usual. When I hook up my Pansat, some channels can't be seen.
I have B-75 installed with the latest keys and still can't see some channels from 110. The message says "Scrambled" or "No Signal".
Could anybody help me? Could it be the dish is not completelly aligned? My installation was made by a Dish professional.

Have you tried just rebooting it, turn off with back switch, wait a couple and then power back on???

[cangrimanjdj]

I even tried disconecting it.

[cangrimanjdj]

I have a neighbor with the same box that I saw have access to some channels I don't.

[jc7257]

What do you have for your LNB type in your SAT settings???

[cangrimanjdj]

Please, ellaborate...?

[jc7257]

In your ant settings, where you first set up your dish, what is in the box for LNB type( single, OCS-DP, legacy, universal )???

[woodcreeker]

You only need to run ONE cable from back of receiver out to ONE of the LNB ports.

Go to Antenna Settings:
Echo 8,10 (be sure it is checked)
LNB Type: Dish-Pro
LNB Freq: 11250
22kHz OFF
DiSEqC #2
Legacy SW None

Exit, Hit OK to Save, Exit go down to Blind Scan Choose Echo 8.10/Ku go down and scan all. When completed, Exit Out. Hit the SAT button, select EchostarPackage. A box will pop up, select any channel by hitting Ok. Channels will all be numbered in proper DN order.

You can go into settings and Menu -> User Setup -> Renumbering Local CH -> Select State and Local City, hit OK to save. Exit out. What this does is it remaps local channels. So, if channel 4 is NBC in your town, hit a 4 on your remote, and that channel will come up. No need to find channel 7892 or whatever again.

Good Luck !!

[cangrimanjdj]

It says STANDARD type right now.

[cangrimanjdj]

I did all the steps, but still there are some, not all, channels from 8.10/ku that appear scrambled or no signal.