5 LNB dish install

[bill of oz]

i just installed my 5 LNB dish and having a bit of trouble.....i get a good signal on 82, 91 and 110 but im getting nothing on 119.....the signal says 70 but the quality stays at zero and never moves

[Apocalypse_67]

Make sure your antenna settings are correct.
Try tweeking the dish a bit to get a good lock on the signal.
Are you using any switches?

[bill of oz]

yes im using a 4 port switch....settings are all okay

[bill of oz]

its a new LNB but could there be something wrong with it??.....if im getting good signals on the rest then the aim should be okay......no??

[Apocalypse_67]

Focal point might be a bit out-of-whack.
Which sat did you aimed at first??

[arcadian9]

try playing around with the TP setting
i think its suppose to be 12239

[creativegenius]

The problem you are having may be attributed to the skew of the LNB in that position (119). You may have to adjust it/them slightly, the geometry of an 18" x 24" will permit for this set up - but you may have to fine tune it slightly.

Creative Genius
P.S. Depending on where you are, you may find that locking onto 110 first helps

[bill of oz]

Originally Posted by arcadian9

try playing around with the TP setting
i think its suppose to be 12239

yeah that was the problem.....i played around with that last night.....my bad

so they are all working good now.....one small problem.....my guide is not updating properly.....alot on channels coming up "no information".....any fix for this?.....i know it takes time to program but its been sitting overnight now so i thought it would be okay this morning

i also get a much better signal on the DN as opposed to the BEV is this normal??

[Apocalypse_67]

Yes, DN shows a little more strenght on it's signal than B3V.
Check and make sure you have te correct time on the receiver for the program guide to fill in.

[creativegenius]

Try changing the TP you are using to scan B3V, I suggest 122253.

Creative Genius

Originally Posted by bill of oz

yeah that was the problem.....i played around with that last night.....my bad

so they are all working good now.....one small problem.....my guide is not updating properly.....alot on channels coming up "no information".....any fix for this?.....i know it takes time to program but its been sitting overnight now so i thought it would be okay this morning

i also get a much better signal on the DN as opposed to the BEV is this normal??