help with channels

[Homie45656]

I have a captiveworks 600s premium and when I scan chanells I only get one ppv channel. What sat does the ppv come off of? Is there a file I can put on this receiver that will fix my channel numbers Thanks.

[tomcat01]

ok what bin are you using and also can you send your antenna setting and what dish and lnbs you are using .. lets get ya going and also switch you are using more info the better

[Homie45656]

Im using the lastest bin and my dish is a dish 500 with 2 lnbs and im not sure what you by sending your antenna. I dont think im using any switch other than the one in the receiver............i think I have just lost everything.

[tomcat01]

hey the antenna setting basically what sats are you going for and what you entered to get a signal and q ..

[Homie45656]

119w and 110w I think are the main sats for DN. I didnt put nothing in maybe thats the problem.......Im getting porn but it skips all ppvs......and when I try to enter channel number it says not a valid channel number. My zip is 45656 but I think that is the main sats. although when i go to 119w it says locking on 110w. im not sure but I think the main sat is 119w. Which sat does the ppvs come off of? Thanks for the help

[tomcat01]

i am not up on the cw 600 but they all have the same settings . go to menu then antenna setting and then you have to setup what kind of dish and lnbs you have .. so you need to knnow .. so i would say go and check bud that way you can set it up properly i will give you a example

echostar 8,10 or 6,8
lnb type -standard
22khz off
diseqc 1.0 port what ever your switch is match up
legacy sw none
transponder or tp 12224
motor off
sat or network all


now do the same for
echostar 7

but change the transponder from 12224 to

12239 and try that and play with the port if you have no signal and look for a good signal ..

so try that

[bigevil69]

go to menu-installation-antenna setting an enter these settings then do a auto scan



sat name--echostar 7 119w
transponder--12239
LNB freq--11250
LNB type---standard
22khz---auto
Diseqc number--auto
legacy switch--off
motorized system---none
found echostar 7 119w

sat name--echostar 6,8 110w
transponder--12224
LNB freq--11250
LNB type---standard
22khz---auto
Diseqc number--auto
legacy switch--off
motorized system---none
found echostar 6,8 110w

[Homie45656]

Thanks alot......One more thing, I am reading the how to program and at the end it says to factory default then set antenna settings. My question is wont that clear the bin off the receiver when you factory default?