|
Re: Is this ok
here is some info for you:
antenna settings
press menu- installation- pin code- antenna setup
sattelite echostar 7 (for example)
lnb power - on
lnb type - universal (depends on dish type, try all selections to be sure you have the right one)
lnb high - 11250
lnb low - 9750
tp freq - 12224
diseqc 1.0 - port (depends on where the cables are on the switch. use none if you only have one dish and lnb) suggested setting, echostar 7(119) port 1, echostar 8,10(110) port 2, nimic 1(91) port 3.
motor - off
legacy sw - none
how to load a bin file
1. download newest bin file from proper area.
2. MAKE SURE you unzip the file (I use winrar). unzip to desktop.
3. open loader 1 or 2 program, whichever one you have.
4. click open files and select desktop.
5. double click file or drag file to loader program. 6. click "open". file appears in box. select it and click open one more time.
7.file is now ready to load onto stb. IMPORTANT- turn switch on back of receiver off
now if you havent done it already.
8. connect your usb- serial cable to the pc and stb now.
if you have a usb stick you dont use the cable
9. click the pc-stb button.
10. turn on the stb with the switch on back now.
11. wait for the file to load and the word "end" to dissapear and the channel # to
return. turn off again with switch on back before you disconnect the usb-serial cable.
12. file is now loaded, reconnect to tv and turn on again only after all connections are done.
13. wait for new file to autoroll and commence testing enjoyment!!
how to autoscan:
1) press menu- go to installation- then autoscan.
2) select the sats you want to scan from the list.
3)press the OK button to start the scan.
as each tp scans you should see the # of channels going up.
EPG SETTINGS
you can set your epg hours from 1-24 hours.
here is how:
go to menu, user settings, epg settings.
on the first line scroll the number to the desired hour.
press exit then yes to save.
you can also set the length of the guide, 1 hour or 2.
also you can set the number of lines on the guide from 1 to 7.
there is a receive epg setting on the first line.
go to "get guide and press ok to get that.
signal and quality issues
if you are having problems with signal or quality try these steps:
* do a hard reboot with the switch on back.
* make sure you have the right sat selected in your antenna settings.
* check your antenna settings to be sure they are correct.
* check all your connections including the switch to be sure they are tight and working.
* if your quality is low or 0 you may need to align your dish.
* make sure you have the latest bin file.
|
Linear Mode
