Re: Help Needed

[ka1300]

I uploaded the new bin file for Viewsat Ulta V2 but just getting Autoroll processing in the channels. Please advise what to do...

[boboisno1]

Wait for a while or turn the back power switch off then on again.

[ka1300]

I left it on on Autoroll processing for 20 mins...no luck...I even turned it off and turned it on back no luck...Please help!!!

[boboisno1]

Make sure your antenna settings are correct. Put it on a channel for 110 say and then go into your antenna settings and make sure the popup screen tells you that you actually have 110.

[cal74]

I'm having the same problem with my VS Ultra

This is my first BIN change since I'd intially installed it.

Left it sit on auto roll, came back nothing. Did a channel rescan, nothing

Just loaded the BIN file again, turned off, un-plugged it, NOTHING

Channel showing is the same as the channel show in the pop up, signal/quality are good.

Suggestions?



*****EDIT*****

OK, just did a hard reboot on channel 200.. Nothing

Re-inserted my USB drive and downloaded again, this time it went through the whole process, which I'd forgot it did last time, as last time was my first time. Ran it's course and now I'm up and running


Now I've got to go outside and get some work done