I lost my echo 7

[begood]

I lost my 119 channels my 119w changed to 360w i went t0 usal and put in 119w but on my viewstat ultra it reads 11.9w i dont know if this makes a difference but every time i try to scan echo 7 or 119 11o shows up when i check my disqc fi it says failed is this because of the 11.9 instead of the 119 or is possible my disqc switch bad or if so how do i get that period out of that 119 any help would be helpful

[buddyjh]

post your settings and dish type along with lnb type

[cdo_care]

The better things to do is start all over again by doing a factory default and setup your antenna setting properly..As the post above, we need to know your setting and the type of LNB.

[bigevil69]

load the sat file then do a factory default setup and autoscan

[cisco123]

please give feedback so we all know.

[begood]

These r my settings lnb power on lnb type standard lnb freq 11250 all setings were working find until my echo 7 went to 360w then i changed it back to 11.9w and it wouldnt pick up the bird for echo 7 i cant get the tp freq 12239 to lock in it always go back to 12224 i cant also get my disq port to lock in all i really need to know is when i put in the usal 11.9 in place of 360 does this have anything to do with my problem

[bigevil69]

if you load the sat file it should change it back to 119

[begood]

For those of you that loss your echo 7 just like me, this is what you can try go to antenna set up then to sat echo 7 go to motor usal set sat to 119 0W exit then go to disq port check port with F1 to see if you have found port fail or sucess if you cant find disq 2 3or what ever you cant get that sat then check the disq port on your echo 8 which is working now what ever you have on that port change it if you have 2 and 3 change it to 1 and 4 this to be done on the receiver and on the disq switch out side. If this doesnt work you might nee d a new disq switch