Adding missing Channels

[Hogpin]

What must I do to add missing channels ie to my SV1000PVR. Dish net. 190, 207, 263. I have rescand several times but to no avail, I have a Sig. 74 and Qual. 90. Must I load a spec. tp no. or what. . .thx

[coorslightly]

the signal could be very weak on those specific channels thats why your not picking it up.

[vpr001]

I'm having the same issue as Hogpin.
What I don't understand is that I used to get these channels with my old FLU and when I flash with Factory Bin 112, I can get the channels, but when I flash with the current bin, I get no signal on those channels.
I tried doing factory reset and then rescanning, and I don't even get the channels on the list.
Any ideas?

Thanks

[carpenter1]

You need to double check your settings you might have overlooked something.
And if your settings are all good then go to LyngSat - Lyngemark Satellite and find the channels on those satellites (under P) and see if you have those TP's in your list. If not then just add them in TP scan of your menu.

[vpr001]

Thanks Carpenter, I was able to get the channels.
I looked at Lyngsat and checked which TPs had the channels that were missing; there were 5, but there were all in my IRD. As I said before, with my FLU, I was able to get the channels with no trouble whatsoever, so I put it back to see how they displayed. I noticed that one of them was on TP 12281 on Echo 6,8 (which on Lyngsat is listed as 12282) and it was not showing so I added that one to the list and when I scanned it, I got all the missing channels from all TPs. Weird, but it worked.

Again, thanks

[Hogpin]

Originally Posted by carpenter1

You need to double check your settings you might have overlooked something.
And if your settings are all good then go to LyngSat - Lyngemark Satellite and find the channels on those satellites (under P) and see if you have those TP's in your list. If not then just add them in TP scan of your menu.

Thanks Carpenter for your clear instructions. . .everything came out perfect. The Hogpin