"scrambled" when changing chs. between sats.

[stephjr]

help tried everything!
I have a dish 500 with 2 lnbs hooked to a disecq 4x1(pansat)I am able to receive both 110/119 channels with no problem as long I am changing
channels within the same sat. Problem exists when I change channels between sats. If I change from a 110 channel to a 119 channel(or 119 to 110) Ill get scrambled message, I turn off/on receiver channel comes in. I have configured the option menu every possible way, changed ports on disecq, changed disecq. Same problem exists.
Any advice would be greatly appreciated.

[mountaineer]

Use a good rg6 cable, make sure switch isn't to far away from the receiver, and it also could be a bad lnb. These are the answers, you have to figure out the problem. My brother-in-law is working on the same thing.

[geelickvb]

which model lnbs are you using??? all lnbs w/ built-in switches are problematic...

[stephjr]

Not exactly sure what the lnb set up is called. The 2 lnbs only say
"digital lnbf". They both go into a holding fixture that has 110 119
slots.

[geelickvb]

is the lnbs the originals that came w/ the dish? Some of The Dish 500 pros has a built-in switch that sometimes will not allow you to switch from 110 to 119 properly... I have encountered this problem and had to change out the lnbs....