Get signal on both 119 and 110, but can't find TP - ABA DSS

calcio2005 · April 7th, 2006

I have signal on 119 and 110, I had some TP scanned and I was watchin channels from both, when I deleted the channels and tried to do a blind scan, it did not find any TP and now 110 only returns 2 TP, any ideas why, and how can I fix this?

**carpenter1** · April 7th, 2006

Do you have a switch in you line? and you don't need to blind scan 110 and 119 you will not get a proper scan just do a normal scan.

**perezcuco** · April 7th, 2006

Check the frequency is 11250, no 10750.

calcio2005 · April 7th, 2006

First of all, thank you for your help.

I have a dish pro 500, I have the pansat switch installed, and I was able to get channels from both 110 and 119, the problem is, that when I did the factory defaults, then I could not get signal on some TPs in the 119. These are my settings Dish Pro, 11250, 20 mhz, disecq #1 110, #2 119.
Only two TPs get signal. Any ideas of what it could be?

calcio2005 · April 7th, 2006

Does anybody knows why I can only get two TPs?

**myxlplk009** · April 7th, 2006

are you sure that 110 is going into the LNB port one on the diseqc switch?and 119 into port 2?
are you using a channel list?
and if you did the factory defaults did you reload a current bin file?

**carpenter1** · April 8th, 2006

What channels are you picking up? And if you can go and scan satellites without the switch.

calcio2005 · April 13th, 2006

First of all, thank you for your help. Well I reloaded the factory defaults first, then I installed the 146 bin, I checked the cables and 110 goes to #1 and 119 goes in #2. I am not using a channel list. I tilted the antena and I was able to pick up tbs, spike, etc. But when I erased the channels to do a blind scan, then I got nothing on 119, I erased the channels and then tried doing a satellite scan for 119, but it did not work. I have not tried scanning with out the switch, but if it would be the switch, then I wouldn't have been able to get those channels right?

theman3435 · April 13th, 2006

Quote:

Originally Posted by calcio2005

I have signal on 119 and 110, I had some TP scanned and I was watchin channels from both, when I deleted the channels and tried to do a blind scan, it did not find any TP and now 110 only returns 2 TP, any ideas why, and how can I fix this?

what new bin

mayum · September 22nd, 2009

Good morning, I have just bought a 18" dish and reciever for dish network from a friend. the smart card and reciever are not yet registerd for programing. can I still still lock on to satellite 119 with out being registerd.

thank you