2 receivers- switch sat lose sig.on one

[michaelsnewt]

have 2 receivers-pan9200-2700.setup is 2 18"dish dual lnb. disq switch set 1 ehco 7 -2 8/10. everything is fine on both tv's on same sat. when i switch one tv over to different sat. i lose sig. on other tv. hope this makes sense to someone. everything was working fine yesterday. checked disq ,i think they're fine. thanks,mike

[bigevil69]

how many cables coming into house

[michaelsnewt]

4 total. 2 to ehco 7. 2 to 8/10

[bigevil69]

how do you have them connected

[michaelsnewt]

not sure what you mean. 1 cable to each sat.2 to each tv

[bigevil69]

do you have any switches installed
how are the wires attached to the receivers

[michaelsnewt]

if input to tv out

[bigevil69]

to get both receivers to get both sats you need either 2 sw21 switches or 2 4x1 disq switches

[michaelsnewt]

i have 2 4x1 disq. switches

[bigevil69]

1 cable from each sat to each 4x1

[michaelsnewt]

2 cables from each sat.1 for each tv

[bigevil69]

post your antenna settings

[michaelsnewt]

ehco 7-lnb-standard-lnb local-freq. 11250 .22khz off. disq. 1. legact sw.none skew -45.positioner set. disable. ehco 8/10 same as 7.only difference is disq. set at 2

[michaelsnewt]

have both tv's on ehco 8/10,same channel.switch 1 tv to ehco 7 and other tv(ehco 8/10 ) goes out for about 5 to 10 seconds then gets signal back.what is this?

[bigevil69]

what is the distance between the box and the switch and the distance between the switch and the lnbs

[michaelsnewt]

switch to box 1foot. switch to lnb about 60 feet