Signal but no Quality - ABA DSS

**odbert2** · July 2nd, 2008

I am still in the process of setting up my SV8000. I am very anxious to see it in action but I am having problems. First, I couldn't upload the newest bin file from my memory stick. It turns out that you can't use a big memory stick for it to work. I bought a small memory stick and was finally able to upload the newest bin file. I go to the Dish setting page and see a a Signal of 59 but a Quality of 0. If I pull the cable out and put it back in, I get high Quality for a few seconds and then it goes away. Is there maybe a problem with the box or with the settings? Here are my settings:

echostart 7
LNB type: ocs-dp
LNB freq: 11250
22khz: off
LNB pw: on
transponder: 12224 or 12239 (whichever works the best)

echostart 8,x
LNB type: ocs-dp
LNB freq: 11250
22khz: off
LNB pw: on
transponder: 12224 or 12239 (whichever works the best)

Is the reason I am getting no Quality because Sonicview is down? My CW800S is working fine. I can't wait to get my Sonicview working!

**bigevil69** · July 2nd, 2008

what are your disqc settings

**odbert2** · July 2nd, 2008

for echostar 7 it is port 1 and for echostar 8 it is set to off. Isn't Sonicview down anyways?

**tomcat01** · July 2nd, 2008

no you can use bin dated the 18 th flash and you are back up

http://www.abadss.com/forum/323-sv80...ted-fixed.html

**tomcat01** · July 2nd, 2008

also i read your first post DO NOT pull the cable out and in you can damage your reciever .. really kill it

**hazwis** · July 2nd, 2008

you also did not tell us what type of dish you have.
yes you will have to load the older bin for it to work today with new ecm.

**jayjay1972** · July 2nd, 2008

your diseqc settings should be the same as your CW and i use a 2gb stick to load to my sv8000 and dont have any problems.

**odbert2** · July 2nd, 2008

The dish is a Dish 1000. Maybe the reason the 1GB memory stick I tried to use failed because of the brand. The smaller one seemed to work. I will try and use the older bin but I'll have to wait to test it because it is raining hard right now and I am not getting a signal, even on my CW 800s. Thanks to everyone for their help.

**arboristman** · July 2nd, 2008

aww man! lol one thing in a row for ya there buddy.

well your in good hands.looks like your getting there.
make sure you have the cable inserted in the lnb in port.
and yeah,never remove that with the rear switch on.make sure thats off first.
then leave that alone.

well hopefully she stops raining so you can set her up.
your going to love this thing!

**odbert2** · July 2nd, 2008

I figured out it was the Transponder. I had to change it to 12239 but once I change it, how do I save the change? I hit ok and then exit but it goes back to the old setting and doesn't save. How do I save the change?

**odbert2** · July 2nd, 2008

Does anyone know how to save the changes in the dish setting page when I change the transponder? I can get 73 strength and 99 quality but can't save it. I hit ok, exit but when I go back to check, the transponder change didn't save. How do I save the change? I am so close.