Loaded 323 but did not seem to fix....

[firstrojoho]

Hi! Yesterday evening I loaded the 321 but it did not fix anything. However, when I went back and checked signal and quality it all read 0. I saw the new 323 load last night but also found it was improperly zipped and thus checked again this morning. Found the new 323 and loaded it up. I still have nothing... I have checked the dish, cables and connectors but still have 0 on signal and quality but have the new 323 loaded. I have an SV800HD.... Can someoone give me a hand on figureing out what went wrong?

Thank You,

Firstrojoho

[boboisno1]

S is for connection from the lnb to stb and Q is signal strength. What sats are you pointing at? What type of dish do you have.

Originally Posted by firstrojoho

Hi! Yesterday evening I loaded the 321 but it did not fix anything. However, when I went back and checked signal and quality it all read 0. I saw the new 323 load last night but also found it was improperly zipped and thus checked again this morning. Found the new 323 and loaded it up. I still have nothing... I have checked the dish, cables and connectors but still have 0 on signal and quality but have the new 323 loaded. I have an SV800HD.... Can someoone give me a hand on figureing out what went wrong?

Thank You,

Firstrojoho

[firstrojoho]

Originally Posted by boboisno1

S is for connection from the lnb to stb and Q is signal strength. What sats are you pointing at? What type of dish do you have.

Hello, I am slow to respond as we had a major system migration over the last several days. Yesterday, I slept..... Today back on a normal schedule.

Okay... I have a direct dish 1000.2 and at present I have it directed to 110 degrees west, and also have the other two LBN on a couple other satelites. NIMQ 2, Direct 1,5, echostar 7, echostar 1,8 .... I am pulling this off the top of my head but I believe this is what the satelite is synced up to.

I am realatively new to FTA but I had a direct TV satelite for quite a few years. My background is technology. Started in telecom and move to networking engineering and for the last 10 years I have been a globe trotter and heard about FTA. My wife is Indian and I got this a couple weeks ago to get away from cable and to figure this out and when I am comfortable with FTA I can then get Indian channels for my wife.

I had the service running for just over a week when the ECM hit. I loaded the 321, 322 and last the 323, which but as I stated it quit running. THe satelite has not moved and the cable is the same (RG-6). The only difference is the 323. Originally, the signal was ocillating between 69 and 70 with quality show 99.

The only difference or change to anything when it started showing 0 signal and 0 quality was when I loaded the BIN 323.

I am new enough not to understand all the idiosyncrosies of hardware and software loads on the receiver.

I am also a bit confused about the keys..... and how to load a key or whether the SV800HD requires them....

Thank you for your support.... I am looking forward to your response

Kind Regards,

Robert Jones

[wayne5222]

Load the lastest factory file then reload new bin, rescan your sats. and you should be ok, same thing happened to me and it worked 4 me

[peggy13]

Just to add to the above post, make sure you write down your sat settings before you reset everything. It makes it so much easier to add them back if you have it all written down.

Don't worry about the "keys". That isn't needed very often, especially if you have your autoroll turned on in your settings. It will get easier as it goes along. Read and learn as much as you can as often as you can. Good luck and enjoy. Don't give up!!