[zekester]

Part 1
1) if your system was using DNS=YES and it works then goto "part 2"
2) Make sure your system works before proceeding.. Check USA (105)
3) Open your IPCONFIG and change to DNS=YES. Confirm Domain is correct, confirm ports, Once you have made sure all is correct check for picture.. if it works continue..if not.. reset router.. reset receiver..check again..
Part 2.
1) Load the new file on the receiver.
2) Open the Wiznet program.
3) Click Search.
4) make sure all the info is as shown below.. ( note: Your IP and Gateway will be different numbers but the same points shown below apply.) all the rest should be as shown in the picture below
5) Once you confirm the settings are correct.. Click "Setting"
6) Click Upload
7) Choose 1.9 (UNZIPPED) file. It will load. Close Wiznet.
8) Open Wiznet... Click "Search"
9) Confirm the Version is 1.9 and all settings are correct.. If anything has changed in settings... leave it alone for the moment and proceed.
10) Turn Receiver off..then On from rear switch.. Check for picture on USA (105). If it works... Close Wiznet..
11) If it didn't work.. Go back to Wiznet and repeat steps 4 and 5.
12) turn off receiver.. Reset router via the web interface. After the router completes its reboot..turn on receiver and look for connected message.
ONCE YOU GET IT WORKING LEAVE IT ALONE... DON'T OPEN WIZNET AGAIN.