dish 1000.2 port/aiming 129 Help - ABA DSS

blackrain21 · March 16th, 2009

I'm using an nfusion(non HD) to get my tuning right because I'm not familiar with my captiveworks4k yet. I can't get 129 for the life of me.

For some reason
port 1 is always 110
port 3 is always 119

supposedly port 3 is 129 but i'm not seeing those results on mine

What am I doing wrong?

**Bud_Alcor** · March 16th, 2009

can you posts your settings on the 3 sats

blackrain21 · March 16th, 2009

110
LNB TYPE: Single/DPquad/DPtwin
11.250
22hz off
discqc 1.0 port 1
discqc 1.1 disable
multi-disc switch disable (same results regardless of setting)
TP 18/25
Power on/18

119
LNB TYPE: Single/DPquad/DPtwin
11.250
22hz off
discqc 1.0 port 3
discqc 1.1 disbale
multi-disc switch disable (same results regardless of setting)
TP 18/25
Power on/18

**creativegenius** · March 16th, 2009

That does seem a bit wierd are you using a Dish 1000.2 set up?

Creative Genius

dirtywill2001 · March 16th, 2009

are you using the coordinates that are in the manual that came w/ the 1000.2.
it sounds like you may be pointing a little off to the left and up.

**cdo_care** · March 17th, 2009

The problem is the alignment of the Dish.

**creativegenius** · March 17th, 2009

Here is the OFFICIAL Dish 1000.2 Install Manual:

http://www.abadss.com/forum/1012-dis...ion-guide.html

Creative Genius

blackrain21 · March 17th, 2009

I used a signal meter to pull in 110/119 rather then relying on the coordinates. I didn't realize doing it this way would produce these awkward results. I'll try it and post back.