Help with Cs7000PVR

[titeo123]

Hello, guys. I need your help on my Coolsat 7000PVR. It used to work fine since last Charlie down and I move to a different room. When I powered it up the display shows "L1.00" and then disappeared. This cycle kept going forever and I could not display the menu on screen to setup the new bin or seach channels. I rebooted the CS7000 several times but the problem still existed. I connected the null cable to download the factory bin file but after power on the CS7000 the display kept cyling between "L1.00" and "100" and off. I could not load the file from the loader. I held the power button on the front while tried to turn on and off the back switch but the unit did not stay on and could not communicate with the computer where I tried to download the factory bin file. Anyone has a clue what is going on with my Coolsat 7000PVR? Please advise. Thanks.

[mandydish]

you got me confuse here body, your post says cw and your explanations are for coolsat, wich one is it?.
anyways if it is a cw700 that is not a pvr the 800 is, but if indeed is a cw by holding the front button and turning it on from the back should work,try it again.

[mandydish]

ok I wass doing some search for you and I think what you mean is coolsat7000pvr.
there is a solution to your problem allready posted by GH in the coolsat help section, I try to transfered it over here but I couldn't, but you can go there and read it. good luck and let us know if it work for you.

[snakebite]

i had a problem with my cs like that and what i eventually did was unplug the reciever for 24 hours and then did factory default and loaded a new file in it.it finally came around ,this was caused by a bad bin.hope this helps

[creativegenius]

This may solve your problem.
c/p originally posted by Grasshopper

How To Recover From The E-01 Error
To Recover from the dreaded E-01 ERROR simply follow my RS232 loading instructions But REPEAT step 4 and 5 Twice BEFORE moving on to step 6

NOTE
ALWAYS Unplug your receiver BEFORE disconnecting Or Connecting your Coax cable Or RCA cables !! FAILURE to do so WILL damage your receiver !


1) Download and unzip both the ( COOLSAT7000_FAC_V0111 ) and NorW latest release

2) Connect your receiver to your computer using your RS232 cable.

3) Open your Coolsat 7000 Loader click the file button and load your Coolsat_7000_Fac_Vo111 into your loader

4) Timing is everything on this step ! Put your mouse over the download button and as soon as you turn the Back power switch on your receiver ON click the download button
If your to slow it will NOT load and you must Repeat this step !

5)When your receiver reboots itself Or you see this ---- turn off the back switch and reconnect it to your TV then click Menu on your remote and then go to Installation screen and select SYSTEM RECOVERY and click YES to (System restore to Factory Default) when the factory reset is finished set the Language of choice and then set your time zone. After setting the time zone the receiver will ask if you want to Auto detect your satellites and switch settings. Say NO at this time !

6)Now Repeat the First 5 steps to load the Latest Coolsat7000_NorW-BIN !
BUT this time say YES to Auto Detect and it will auto set your LNB type and switch settings and then scan All the satellites your pointed at !


NOTE
ALWAYS Unplug your receiver BEFORE disconnecting Or Connecting your Coax cable Or RCA cables !! FAILURE to do so WILL damage your receiver !

Creative Genius