How To Manually Load Keys For Coolsat STB's
Here's how to manually Load Keys for the Coolsats:
On your remote control,
Press
8282, this will bring up the
Key Edit menu. The #1 box at the top should say Nagravision. If box #1 does not say Nagravision, you may need to scroll to box #72 using the right or left arrow buttons on your remote. The CAS should read Nagravision. The Ident should read Dish Network (0001), below that, there should be 4 boxes on the left that have 10, 11, 20, 21 in them with numbers and letters to the right of those numbers. This is where the current key data is located and may need to be changed manually from time to time. Autoroll files normally make these steps unnecessary but the occasional unforseen circumstances make changing the data necessary but easy to do.
UPDATED INSTRUCTIONS/INFO:
Press the down arrow button to highlight whichever is the
Current Active Key(s) which will be either
10 or 11 = Key 00 Data ( 16 numbers/letters ) / 20 or 21 = Key 01 Data ( 16 numbers/letters ) or both as determined by the Key gathering program you are using such as CyberDBS, KeyMaster, Get Keys, Jeepers, Maestra etc., which can be found in the Tools and Utilities section under STB Channel Lists and Tools
From the Current
Active Key Data Information (numbers and letters) you wrote down,
Press the corresponding numbers and letters using your remote
There are 2 different methods to input the numbers and letters:
1)To input the needed Numbers, press the corresponding number on your remote and it will automatically move to the next space for data input
To input the needed Letters, press the
Info button on your remote and it will change the letters with each push of the Info button. When you have the correct letter or number inputted, press the right aarow button and it will move to the next space for data input.
2) To input the needed Numbers and Letters, press the
OK button on your remote and it will bring up a small letter and number menu. Using the up/down, right/left arrow buttons on your remote, highlight the needed number or letter and press OK. This will input the needed number or letter and automatically move to the next space for data input.
Once you have all the Key Data (numbers and letters) inputted all the way across for the corresponding Key Number(s) (10/11 or 20/21), double check to make sure all the information is correct.
Press the EXIT button and a box will appear on your screen that says;
Settings Were Changed
Do You Want To Save?
Yes - No - Cancel
Highlight the YES button and press OK
That's it. In most cases, the screen should either have a picture on it right away or in some cases, it may be black ( with no message at all ) and take a few minutes for the active key to update to your receiver and then the picture will automatically pop on. Hope this helps.
