[wildbill1963]

I found this info and not sure if it works or not:

"The new 201 bin file will not work if you use your old channels. I have tried and comfirmed this. Also it can cause Echo 8.10/Ku to show no signal. Could be why 61.5W is not working, too. Factory Reset first. Reload the bin and keep the receiver powered On and manually set the satellites back up, then blind scan the channels in one satellite at a time.

Blind scans are the recommended scan for these receivers.

Write down all your antenna settings before you do a Factory Reset and always keep your settings in a safe place. Some tuck them in their manual.

Setup satellites, Exit, Ok to Save on each one.

Go down to blind scan, and do each one once, seperately.

This file is working, and later releases may do the same thing."