ABA DSS - Free to Air Satellite TV Community - View Single Post

**VGiddy** · February 21st, 2009

This is a common problem faced by many due to a bad load of the bin.
Do the following:
Press and hold the front Power button and switch it ON from the rear toggle switch.
You should see BOOT on the receiver. Now open your 1.5 Loader and load the latest bin file. Wait till it says END. Switch off the receiver from the rear toggle switch. Take it to your TV, do a Factory Default, re enter the Antenna Settings and Scan in the Channels and then do not forget F1 000 to enable patch and watch TV.

February 21st, 2009	#3 (permalink)
VGiddy Veteran Abadss Member Join Date: Nov 2007 Posts: 1,778 Credits: 1,736.75 Thanks: 144 Thanked 1,165 Times in 674 Posts	Re: Error Codes This is a common problem faced by many due to a bad load of the bin. Do the following: Press and hold the front Power button and switch it ON from the rear toggle switch. You should see BOOT on the receiver. Now open your 1.5 Loader and load the latest bin file. Wait till it says END. Switch off the receiver from the rear toggle switch. Take it to your TV, do a Factory Default, re enter the Antenna Settings and Scan in the Channels and then do not forget F1 000 to enable patch and watch TV.