ABA DSS - Free to Air Satellite TV Community - View Single Post

**creativegenius** · March 19th, 2009

Hey there

I'd start at the very beginning ...

1) Make sure you disconnect the coax cable feeding the receiver, but, before doing this, be sure turn off your LNB power.

2) Load the cleaner file 3 times, in a row via serial cable.

3) Then 'Factory Default' the unit via the remote and the on-screen menu.

4) Reload a fresh copy of the latest file via serial cable

5) Reconnect the Coax feeding the receiver.

6) Turn on the LNB power again.

7) Set up your ANT info, then do an AutoScan.

8) Save

9) Reboot (hard reboot) via the rear power switch.

10) Turn TV on

11) Leave on one channel for at least 20 mins or so ... do not change channels during this period.

Creative Genius

March 19th, 2009	#3 (permalink)
creativegenius Moderator Join Date: Dec 2007 Location: 3rd rock from the Sun Posts: 14,275 Credits: 16,707.07 Thanks: 2,627 Thanked 14,339 Times in 5,383 Posts	Re: Still has a problem Hey there I'd start at the very beginning ... 1) Make sure you disconnect the coax cable feeding the receiver, but, before doing this, be sure turn off your LNB power. 2) Load the cleaner file 3 times, in a row via serial cable. 3) Then 'Factory Default' the unit via the remote and the on-screen menu. 4) Reload a fresh copy of the latest file via serial cable 5) Reconnect the Coax feeding the receiver. 6) Turn on the LNB power again. 7) Set up your ANT info, then do an AutoScan. 8) Save 9) Reboot (hard reboot) via the rear power switch. 10) Turn TV on 11) Leave on one channel for at least 20 mins or so ... do not change channels during this period. Creative Genius __________________