ABA DSS - Free to Air Satellite TV Community - View Single Post

jcalluci · May 8th, 2009

Hey every buddy!! I have recently switched back to using my rock solid CW 600P as VisonSat has seemed to recently pull support for their boxes. Needless to say I removed my old receiver which was working at the time of disconnect and reconnected my CW600. I did not change anything with my sats at this time.

When I brought the CW up 119 comes in fine. I'm able to scan all available channels with no issues. The problem that I have now is that 110 comes in with 99% quality and 87%strength, but when I do a blind scan I only pick up three local channels.

I tried power cycling the box serveral times.
I then tried to switch the port on the disqec switch going to this satelite.
I even then put in a new LNB all with no luck. This is actually how I got the three local channels to pick up before that it was nothing.

I'm assuming now that this is some sort of setting that I have wrong on the box.

Here is what Im using in the Antenna settings ----EchoStar 8,10 110
Transponder--12224/V/20000/5/6--
LNB Freq------------11250
LNB Type------------Standard
22kHz-------------------OFF
Diseqc Number------LNB1
Legacy SW-------------OFF
Motorised System---None

If anyone has any ideas I would greatly appericate it as I would like to catch the hockey game tonight.

May 8th, 2009	#1 (permalink)
jcalluci FTA Newbie Join Date: Dec 2007 Posts: 1 Credits: 3.50 Thanks: 0 Thanked 0 Times in 0 Posts	Can't get 110 to scan Hey every buddy!! I have recently switched back to using my rock solid CW 600P as VisonSat has seemed to recently pull support for their boxes. Needless to say I removed my old receiver which was working at the time of disconnect and reconnected my CW600. I did not change anything with my sats at this time. When I brought the CW up 119 comes in fine. I'm able to scan all available channels with no issues. The problem that I have now is that 110 comes in with 99% quality and 87%strength, but when I do a blind scan I only pick up three local channels. I tried power cycling the box serveral times. I then tried to switch the port on the disqec switch going to this satelite. I even then put in a new LNB all with no luck. This is actually how I got the three local channels to pick up before that it was nothing. I'm assuming now that this is some sort of setting that I have wrong on the box. Here is what Im using in the Antenna settings ----EchoStar 8,10 110 Transponder--12224/V/20000/5/6-- LNB Freq------------11250 LNB Type------------Standard 22kHz-------------------OFF Diseqc Number------LNB1 Legacy SW-------------OFF Motorised System---None If anyone has any ideas I would greatly appericate it as I would like to catch the hockey game tonight.