Hello,
I just setup a the following but am now only able to pickup a fraction of the channels I previously had:
Dish= 33"
Motor= 2100- H-H
Switch= Model S-4120-GX Eagle Aspen 5x2 (22kHz switch)
LNB= Invacom Quad (dual polarity)
Receiver= Viewsat Ultra
First of all the installation instructions for the switch are very fague. I called Sadoun where I purchased it and didn't get very recommendable customer service.
My question is:
What is the best way to connect the lnb/quad to the switch?
Should the linear lnb's be on the same "sat" input on the switch? Or should there be one circular lnb and one linear lnb be connected to each sat.
There are a total of four coaxial input for the lnb's.
Sat A- shows (18V/0kHZ, 14V/0kHz)
Sat B- shows (18V/22kHz, 14V/22kHz)
Here is a link to the switch I have:
http://www.sadoun.com/Sat/Products/E...pen_Switch.htm