[bill of oz]

without going into alot of detail.....and no offense meant by this.....but you seem like a bit of a newbie, and that switch will most likely just end up making things more difficult for you then they should be.....

to make things easier for you i would really recommend just using a 22khz switch or a 4x1 diseqc switch instead.....

one wire from your reciever to the motor input.....one wire from the motor output into the switch.....then two wires from the switch to the LNB.....one wire to a "C" port and one wire to an "L" port.....

now when setting up your satellites you need to select the proper port on the switch depending on if its a circular or linear satellite.....

the switch you have now would need 4 wires off the LNB.....

- one wire from "C" port one to a 13V input
- one wire from "C" port two to an 18V input
- one wire from "L" port one to the other 13V input
- one wire from "L" port two to the other 18V input