Quote:
Originally Posted by greenhornsat
I have a dish 1000.2
satellite 119
lnb power on
lbn type ocs-dp
lbn freq 11250
22khz off
tp freq. 12224
diseqc 1.0 port 1
motor off
legacy sw none
s 67 q 91
110
all the same except port 2
s 67 q 0 (now if a put p1 then q goes to 91)
129
all the same except
lnb freq. 11000
and port 3
s 67 q 0 (same deal with port 1 it jumps to q 87 when I do that)
Do I have to separate the ports?
I have done it both ways and not had luck.
|
Your settings appear good, 119, Port 1; 110, Port 2; 129, Port 3. Change TP for 119 to 12239 or on until you get a good signal.
If you are getting good Q and S from all three, then I believe you might be hitting on one of the channels that has gone to Nag 3. Put it on Channel 200, 202 and let it autoroll. Should bring it in. A lot of the channels have done the switch and so you will need to hit on an "active" channel for the autoroll to complete. Do not continue to change channels, as this will cause the autoroll to start over.