ABA DSS - Free to Air Satellite TV Community - View Single Post - Motor, no signal question and/or Help Please

**VGiddy** · June 23rd, 2009

I think your problem is that you manually moved the dish at one time and as a result you have lost your Logitude and Lattitude information on the CW receiver.

What you need to do now is move the dish back to where it was, use the CW700 and go into menu>installation>usals settings and put in your Lattitude and Longitude. Then go into DiSEqC1.2 and move the motor till you reach 119 and save that position. Then move it to 110 and save that position, then move it to 91 and save that position. Now you can scan all these channels and you will find the motor will move to the sats on its own.

However, if you change the receiver, then you have to do all of the above for that receiver.That was your problem. You were under the impression that since you have setup the motor for the CW that it should work with the NF. No it wont.

All the positions were saved on the CW. The NF does not have that same info in its memory. You need to do it again and save it for NF.

I hope this information is clear toyou.

June 23rd, 2009	#2 (permalink)
VGiddy Veteran Abadss Member Join Date: Nov 2007 Posts: 1,772 Credits: 1,680.65 Thanks: 142 Thanked 1,148 Times in 671 Posts	Re: Motor, no signal question and/or Help Please I think your problem is that you manually moved the dish at one time and as a result you have lost your Logitude and Lattitude information on the CW receiver. What you need to do now is move the dish back to where it was, use the CW700 and go into menu>installation>usals settings and put in your Lattitude and Longitude. Then go into DiSEqC1.2 and move the motor till you reach 119 and save that position. Then move it to 110 and save that position, then move it to 91 and save that position. Now you can scan all these channels and you will find the motor will move to the sats on its own. However, if you change the receiver, then you have to do all of the above for that receiver.That was your problem. You were under the impression that since you have setup the motor for the CW that it should work with the NF. No it wont. All the positions were saved on the CW. The NF does not have that same info in its memory. You need to do it again and save it for NF. I hope this information is clear toyou.