ABA DSS - Free to Air Satellite TV Community - View Single Post - Motor, no signal question and/or Help Please

**tomcat01** · June 24th, 2009

Note: 1.Check your receiver first if it works with DiSEqC 1.3(USALS) or only works with
DiSEqC 1.2.
2. Antenna reflector shape is easily damaged by your strong hand force or by
overtightening back mount bolts.
3. Each satellite can be programmed using either USALS or DiSEqC 1.2
independently.
4. If off tune, the following may be necessary for some satellite:
4-1) USALS( Change satellite location number )
4-2) DiSEqC 1.2( Manually tune and store )
5. Preprogram CH list for DiSEqC motor: refer to chart #2
6. Antenna elevation mark may differ with certain brands. In this case. set to the proper
elevation mark using chart #1 and adjust the antenna elevation until the best quality is
achieved.
7. If the motor fails to move to the correct position, resynchronize the unit by using
the “1.2 and go to reference” operation. Then go back to USALS.
8. If motor does not move*, reset** the multi connector located at main board inside the
motor (take the plastic module out).
9. It is not recommended that the east/west buttons be used as they may jam.

* this may occur when the module is replaced or if East/West button is frequently used
** to reset, remove the main board module located inside the motor, unplug and then re-plug the multi-connector

June 24th, 2009	#14 (permalink)
tomcat01 Super Moderator Join Date: Aug 2006 Location: north pole Posts: 7,634 Credits: 14,380.18 Thanks: 852 Thanked 7,984 Times in 2,772 Posts	Re: Motor, no signal question and/or Help Please Note: 1.Check your receiver first if it works with DiSEqC 1.3(USALS) or only works with DiSEqC 1.2. 2. Antenna reflector shape is easily damaged by your strong hand force or by overtightening back mount bolts. 3. Each satellite can be programmed using either USALS or DiSEqC 1.2 independently. 4. If off tune, the following may be necessary for some satellite: 4-1) USALS( Change satellite location number ) 4-2) DiSEqC 1.2( Manually tune and store ) 5. Preprogram CH list for DiSEqC motor: refer to chart #2 6. Antenna elevation mark may differ with certain brands. In this case. set to the proper elevation mark using chart #1 and adjust the antenna elevation until the best quality is achieved. 7. If the motor fails to move to the correct position, resynchronize the unit by using the “1.2 and go to reference” operation. Then go back to USALS. 8. If motor does not move, reset* the multi connector located at main board inside the motor (take the plastic module out). 9. It is not recommended that the east/west buttons be used as they may jam. * this may occur when the module is replaced or if East/West button is frequently used to reset, remove the main board module located inside the motor, unplug and then re-plug the multi-connector __________________ DO NOT PM ME TO E-MAIL FILES I WILL NOT !! THANKS** please ask your questions in the forum do not pm me please!!