Quote:
Originally Posted by jc7257
I would check the board and make sure it is plugged into the connections tight. Unplug the two connectors inside and then plug them back in. Also make sure the loop out is right...
|
I did that check last night and found nothing loose. Still did the unplug and the re-plug. But! Your last statement: "Also make sure the loop out is right." That is something I am not sure about. Could that be the very short cable with an "F" connector on each end? If so, where does it connect to. There was NOTHING in the paper work that came with the unit about that small cable.
R.T.