[Jacques d'Boeuf]

back to your question. make sure you save your position when you lock in signal.




To find new satellites,

go to the dish setting menu and enter the correct info like
10750 for the LNB freq
port 1 on your diseqc 4x1 (if thats where you connected the linear lnb)
a strong transponder freq/polarity/symbol rate

save that info then.....

tune to a satellite that you have locked in already

go to the dish pointing menu. you should still be on your satellite you were just watching.

navigate through the menu to the satellite you want to get

move the dish in the direction of your new satellite.

the signal should spike if you set your transponder right. (some are beamed too, choose a conus transponder)

fine tune the position till its peaked signal. make sure you save your position when you lock in signal ( i said that twice, its important)

Manual scan transponder if you have time, but a blindscan works nice unless you are near circular crap, then it shoots up all kinds of triple channel garbage.