[PLIMZOL]

My setup is a STAB HH120; 33" offset dish; Invacom QPH 31 (2 circular 2 linear standard outputs); Pansat 6000hxc reciever. My dish is aligned to my southern most satellite (which is exactly my longitude, lucky me). To align the dish I used a single linear output to the reciever; bypassing the motor. Getting in the 90's strength and 80's quality after a smart scan. I'm pretty sure I have it peaked. All the FTA channels that should be there, are there.

I now want to check how it tracks the clarke belt and the other satellites. I wish to try 119 first. It's a circular polorized satellite. I have a 4x1 DiSEqC. Inputs labeled sat 1, sat2, sat3, sat4. I am only interested (for now) in a singal circular and a singal linear output. The other two will be terminated (75 ohm terminator). The connections, if I understand correctly, would be one circular output to sat1 and one linear output to sat2. Out from the DiSEqC to the LNB connection on the STAB motor. On the STAB motor the REC connection goes to the 1 IF connection on the Pansat 6000hxc reciever.

Here is where I need help. I have read that the output from each LNB has to be identified by a tone burst (set on the reciever) in order for the reciever to recognize which output to use. I have look thru the menus and find no such selection.

This leads me to a second question. When I choose the method to use the dish motor, I can select either DiSEqC 1.2 or USALS. Which should I choose. Does one have advantages over the other.

plimzol